Locked Table / Tab

Locked Table / Tab

How to unlock a Table/Tab 

As for your stuck table, if you scan a manager card on any terminal at the top middle of the "Manager Menu," there is a button that says "Clear Table/Employee Locks" this will allow you to access the check that was locked on the terminal that went out. 


    • Related Articles

    • Dining Area - Prompting For Table Name

      If you have a dining area where you want to input a table name upon opening a new check / table , you have to verify one setting is checked. - In the manager console, navigate to Setup > Revenue Source Setup > Dining Areas - Select the dining area ...

    • How to Recall Past Transactions

      Going over pos transaction query and reprint historical check from the manager menu. To look into a transaction: 1) Open onePOS Management Console 2) Click POS- POS Transaction Query You can filter by Employee, Revenue Center, Dining area, Payment ...

    • Closing a Tab

      Closing a Tab Open the tab you wish you close. Ensure all items have been rung up. Touch “Close Check” at the bottom of the screen. Touch “Prepay”. How to close a tab To apply the total amount due to the original credit card used when opening this ...

    • Opening a Tab

      Opening a Tab NOTE This procedure will automatically open a new tab, name this new tab with the name on the credit card, preauthorize the customer’s credit card for the pre-set amount for your establishment while retaining the card info for later ...

    • Restarting an Access Point (AP) powered over Ethernet (POE)

      Restarting an Access Point (AP) powered over Ethernet involves a few steps. Follow these instructions: Identify the Access Point: Locate the specific Access Point that you want to restart. It might be connected to a network switch or a Power over ...